Introduction My Builder's Log My Flight Log Tips List of Builders Gallery Ideas for Paint Links News



Empennage
1. Cut out rudder and finish
2. Rudder controls in empennage
3. Fit Elevators and finish

Fuselage
1. Fuselage close-out bids
2. Fit NACA fresh air scoops
3. Fit main gear doors

Canopy

Cockpit Area
1. Fit rudder pedal floorboards
2. Install Rudder pedals
3. Fit fuel selector mount
4. Fit fuel pump mount
5. Fit hydraulic line supports and drill bulkhead penetrations
6. Fit seat belt mount
7. Locate inner gear door cylinders
8. Fit elevator controls
9. Install control yoke & aileron push tubes
10. Fit center console
11. Fit flap torque tube
12. Fit seat pans

Baggage Compartment
1. Bond in flap motor bracket
2. Fit baggage compartment close-out
3. Fit baggage compartment floorboards
4. Install hydraulic pump
5. Install hydraulic lines

Instrument Panel & Firewall
1. Fit instrument panel
2. Fit electronics shelf
3. Install heater/defroster system
4. Fit glare shield

Install main landing gear

Install Engine mount
Fit cowling
Fit nose gear doors

Bond rear windows




Home | Introduction | My Builder's Log | My Flight Log | Tips | Legacy Builders | Legacy Gallery | Ideas For Paint | Links | Legacy News

Copyright © 2005. All rights reserved. This site is the builder's log of Don Barnes and for the purpose of sharing information and opinions related to building a Lancair Legacy. Any person using these images, ideas and tips does so at their own discretion and risk. No responsibility is expressed or implied and is without recourse against anyone related to this site. This site is not affiliated with Lancair International or Neico Aviation Inc., however, we love their aircraft.

Design by Cellar Ideas and produced with GoLive CS. Hosting generously provided by Rob Logan